What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
Last Updated: 28.06.2025 00:06
Barnstars:
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
In schematic diagrams this is the symbol for a fuse:
Jennifer Garner and Her Boyfriend Are Kissing in Public - The Cut
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
but this device (an Inductor) … impedes the rapid changes in the current.
A circuit breaker is similar, but is resettable.
At one ohm, the resistor has a maximum of 1 watt power.
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
Nintendo Switch 2 doubles FPS of Switch 1’s “worst” performing games - Dexerto
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
what exactly is a ‘surge’ protector?
Why is it rare for someone to despise both the Democrats and Republicans?
nine
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
But… the neutral is now “floating” because of the 1 ohm resistance.
Patti LuPone stuns Broadway as The Apologizer - AV Club
the problem then depends on "how fast does the fuse operate?".
This is where this question deviates from being a 'generic' question, and becomes more specific.
He then describes the function of a fuse.
"Brokeback Mountain" broke hearts on the big screen, and it's back to do it again - Salon.com
There are two important concepts here.
One
An AC voltage/ current source, and an ac inductive load.
The third is lightning and “how it gets conducted into a home.”
(Dc diagram shown, AC is similar).
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
Indiana Pacers assistant Lloyd Pierce taking lessons for next opportunity as head coach - Andscape
One is “what exactly is in a ‘surge protector’ ? ”
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
[old diagram got deleted by accident]
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
Do conservative white women like black men?
For this case there are devices called Metal oxide varistors (MOV).
eight
This is 'the assistant's answer'
but I think this circuit , shows a few more pieces.
The other is “what does a “fuse” do?”
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
[image of Common-mode choke]
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
This is the picture of an electronic coil of wire wound around a core of magnetic material.
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
A fuse is a non-resetable over current circuit protector.
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
I post the exact comment here.
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
Edit 2024–10.
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
Upvotes:
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
It also is a device that limits the change in current flow.
The MOV will conduct when the voltage exceeds 50% of line voltage.
Here is a simplified AC power diagram.
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
2024–10–14 [Omar Gharbi Omar Gharbi ]
These devices are installed between the “hot” and “neutral” and protective ground.
so, what happens?
This one hit behind the barn.
Because the load is inductive, the current lags the voltage.(by a bit).
2024–10–16 [ OO OLAOYE OYEBODE ]
Can the fuse protect the electronic devices from lightning instead of a surge protector.
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
These are simplified answers to the original question, and does not change anything I wrote above.
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
So, the voltage could go up to 500 volts, and the fuse will not open up.
But it can get overloaded, and no longer works.
He then asserts :
He then describes Rainy Season and Lightning.
a photo is worth a thousand words.
First Sentence:
What is lightning?
What does a fuse do?
It seems Mohan does not understand the difference between a comment and an Answer.
There are three different concepts here that are getting confused.
The bolt then partially travels down the line to your home.
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
At least they know the answer if they wanted it.
This device then solves the entire problem.
2024–10–10[John johnson John Johnson ]
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
This is where the MOV conducts again, and dissipated the energy.
Now when you have a certain ac resistance, then a current flows in a loop.
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.